OBD-II Fault Code

B1509: Flash To Pass Switch Circuit Short To Battery

Meaning, symptoms, likely causes, diagnostic checks and repair guidance for B1509.

System family

Body

Manufacturer-specific

Repair category

Power supply / charging

Use this category to narrow your checks before replacing parts.

Severity

High

Severity is a general guide. Confirm with scan-tool data and vehicle symptoms.

What B1509 usually means

Flash To Pass Switch Circuit Short To Battery.

Common symptoms

Body/accessory warning lamp or feature not working

Likely causes

Weak battery; Charging system fault; Loose/corroded terminals; Poor ground; Wire shorted to power feed; Incorrectly repaired harness; Internal component short

Diagnostic checks

Check related fuses, connectors, grounds and switch/module power supply; Test battery state of charge and charging voltage; Inspect terminals and ground straps; Check for unwanted voltage on signal/control circuit

Repair guidance

Clean/tighten terminals, replace weak battery, repair alternator/charging circuit as needed; Repair harness short to power or replace internally shorted component

Verification after repair

Operate the affected body/accessory system and rescan

Note: Confirm vehicle make/model/year because manufacturer-specific codes can vary; Manufacturer-specific: confirm definition and test steps in the vehicle service manual. A DTC identifies a circuit or system condition, not always the failed part.